Eliminator XL29 Insulated Siding
w/ patented Glide-Lock Attachment System
"The only 29' Siding Panel on the market today!"

Our new and patented attachment system is designed to stop the expansion and contraction problems when vinyl siding is nailed or attached incorrectly. Our ferrule studs are evenly spaced in 4” increments.

You no longer have to worry that a nail was placed too far to one side of the nailing slot, or angled too high or low. By fastening the siding through the ferrule studs, each fastener is now in the correct position.

The ferrule studs also prevent the nail from being installed pointing upward or downward. Now the attachment strip is fastened to the wall and allows the siding to expand or contract freely. Eliminator XL 29 is attached with exterior coated screws for a peace of mind installation.

ELIMINATOR XL29   VS. 12' ORDINARY SIDING PANELS
 

About the Glide-Lock attachment system
Eliminate siding like this by requesting the Eliminator XL 29 Glide-Lock!

The way vinyl siding is attached to your home today is the same as back in the late 1950’s. The siding panels have improved greatly but the nailing hem hasn’t changed much in almost 50 years. According to The Vinyl Siding Institute’s installation instructions, every nail must be installed exactly in the center of the nailing hem nail hole. If you are too far to the left or right, it can interfere with the expansion and contraction of the siding and you will see warping, wavy walls. Each nail must also be installed straight into the wall, no pointed upward or downward. And to make matters even harder, each nail must be installed leaving 1/32” away from the wall. This must be done approximately 2500 times on an average siding job. If it’s not done perfectly all 2500 times on an average siding job you could see wavy, warping walls as seen in photo.

Continental Manufacturing has designed a patented systems to eliminate the inherent problems with a normal nailing hem on all other vinyl sidings.

Eliminator XL 29 Insulated Siding

Features & Benefits:

• Ferrule studs every 4” on center to guide the installation screws into there proper position

• Leaves 1/32 gap between the wall and siding allowing the siding to expand and contract freely.

• 300 % Greater impact resistance than ordinary siding

• Supports the panels from one end to the other eliminating the possibility of sagging

• Increases the wind load to over 270 mph

• Dramatically increases attachment strength

• Siding is fastened to the wall with screws rather than nails. Provides for 100% piece of mind installation

• Energy Savings Plan of 25%

• R- Value up to 7.0

• Elegant brushed wood finish

• Double 4.5” Clapboard and dutch lap, Double 6” & 3” over 6”

• .048 premium gauge panel thickness

• 29 foot panels allows for a virtually seamless installation

• Available in range of beautiful architectural colors

• Lifetime Written Warranty including color fading